Stats

  • Locked Locked
  • Replies 1
  • Subscribers 165
  • Views 12620
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Capture jumping sheets when selecting nets

OrCadUser9

In a multi-sheet project, when selecting certain wires, Capture will open and jump to a different sheet that is connected to that same net; particularly for power and ground nets, but the issue does not seem to occur for all wires connected to these nets. Is this due to particular feature I've accidentally turned on, or is it some sort of bug?

I experienced this on this project before, but the issue seemed to stop occurring after updated from the 008 hotfix to 011, but has since started happening again. Any help would be greatly appreciated.

I'm using OrCAD Capture 17.4-2019 S011

  • redwire

    I reported this exact bug a while back and it was recognized by Cadence and fixed...I don't have HF011 loaded but I'm not surprised that they let the bug back in

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.