Stats

  • Locked Locked
  • Replies 1
  • Subscribers 164
  • Views 12947
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Verifying schedule

archive

Hello,

Does anybody have any luck scheduling xnets in an ECset and then have them verify in CM? I have derived an ECset from one xnet and applied it to that net, yet the schedule results in the wiring tab say that the xnet does not verify. This just does not seem right. If I create an ECset from an xnet, then it sure ought to at least verify the schedule at a minimum.


Originally posted in cdnusers.org by steffenh
Parents

  • It does verify the schedule so something must not match your topology. One thing to look for is if you have stubs in your design, but no stub length defined in the ECset. That will cause this message.


    Originally posted in cdnusers.org by Padmin
Reply

  • It does verify the schedule so something must not match your topology. One thing to look for is if you have stubs in your design, but no stub length defined in the ECset. That will cause this message.


    Originally posted in cdnusers.org by Padmin
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.