Stats

Locked Locked
Replies 2
Subscribers 166
Views 11707
Members are here 0

Allegro PCB Design Link issue

ichliebedich over 3 years ago

Hi All

I followed tutorial video below for using Design link

https://www.youtube.com/watch?v=f9JmFF8lqA0

and I followed the video with embedded board design file which should be same one on video

I did every set. but at 2:55 of video, Steve have the tabs of both design names on top of Constraint Manager in video

but my one didn't exist them

which one would be different?

there was some comment on command windows but I think they would not be problem here

regard

steve over 3 years ago

Difficult to debug from this but it looks like your Design Link isn't correct. Try recreating this and see if that helps.
Cancel
Vote Up 0 Vote Down

Cancel
ichliebedich over 3 years ago in reply to steve

sorry I omited the Analye - initalize
Cancel
Vote Up 0 Vote Down

Cancel

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.