Stats

  • Locked Locked
  • Replies 0
  • Subscribers 164
  • Views 12417
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Differential pairs: defining the end points.

archive

In one of our designs, I have a differential signal, connecting 96 relays, in four banks of 24, to a single relay. The constraint manager selects only one set of end points, and leaves the primary gap and phase unchecked in three of the banks. Is there a way to manually assign the pin pairs?

Harold Pattie
hpattie@entrisphere.com


Originally posted in cdnusers.org by Hpattie
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.