Stats

  • Locked Locked
  • Replies 4
  • Subscribers 164
  • Views 14449
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

display rat ts

archive

how do you display rat ts?

thanks.


Originally posted in cdnusers.org by KenM
  • archive

    Hi Ken,

    If there are any rat ts made using net scheduling, then you can just view by viewing in information->rat ts checked.


    Originally posted in cdnusers.org by pavan_m_33
  • archive

    Hi Ken,

    If there are any rat ts made using net scheduling, then you can just view by viewing in information->rat ts checked.

    regards,
    Pavan


    Originally posted in cdnusers.org by pavan_m_33
  • archive

    Hi Ken,

    I also found out other method.Just check setup->user preferences->category:etch->ratt_of_if_connected.
    This might help you.

    regards,
    Pavan


    Originally posted in cdnusers.org by pavan_m_33
  • archive

    i needed to change the rat t size in set up - drawing options - display.


    Originally posted in cdnusers.org by KenM
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.