Stats

  • Locked Locked
  • Replies 0
  • Subscribers 164
  • Views 12415
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to prefer conections over conflicts?

archive

I'm trying to run the autorouter. It seems the software often leaves one or two wires un-connected just to reduce a few of the conflicts. I prefer it gets all the wire connected. For the conflicts I may reduce the via and line width. How to set the software to prefer connection over conflicts? Thanks for any advice.


DL


Originally posted in cdnusers.org by DTLPCB
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.