• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  • Site
  • Community Search
  • User
Forum - Thread List
  • Discussion

    Can i change font in the Allegro PCB Editor? Locked

    14473 views
    0 replies
    Started over 11 years ago
    by Dhamodharann
  • Discussion

    How can i create a netlist from only one of multiple schematic? Locked

    16660 views
    2 replies
    Latest over 11 years ago
    by Usane
  • Discussion

    Constraint Parallel Rules Locked

    13462 views
    0 replies
    Started over 11 years ago
    by darrduq
  • Discussion

    Can Cadence find out the incorrect-connecting : Two Alias on the same wire Locked

    15106 views
    2 replies
    Latest over 11 years ago
    by xiaoyi594
  • Discussion

    dxf update Locked

    13887 views
    2 replies
    Latest over 11 years ago
    by Csizi
  • Discussion

    Skill Debugger

    13470 views
    0 replies
    Started over 11 years ago
    by ageraci
  • Discussion

    extracting director from fully-qualified-file-name using rexCompile

    14364 views
    2 replies
    Latest over 11 years ago
    by B Bruekers
  • Discussion

    Route and Package Keepin Different on Top and Bottom Locked

    17198 views
    4 replies
    Latest over 11 years ago
    by teevskis
  • Discussion

    Missing Help documentation? ("Learning PSpice") Locked

    927 views
    1 reply
    Latest over 11 years ago
    by steve
  • Discussion

    Text block setup in PCB designer Locked

    17324 views
    4 replies
    Latest over 11 years ago
    by steve
  • Discussion

    Pour keepout Locked

    16322 views
    2 replies
    Latest over 11 years ago
    by chads108
  • Discussion

    Exporting the .brd to .dxf file the drill figure is not get enabled. Locked

    16037 views
    2 replies
    Latest over 11 years ago
    by Dhamodharann
  • Discussion

    BOM excel file(.xls) should be linked while generation? Locked

    15085 views
    3 replies
    Latest over 11 years ago
    by Dhamodharann
  • Discussion

    Simulating the IR2104 Locked

    14566 views
    1 reply
    Latest over 11 years ago
    by oldmouldy
  • Discussion

    Change component footprint while editing Board Locked

    14722 views
    3 replies
    Latest over 11 years ago
    by oldmouldy
<>

© 2026 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information