Following Cadence Design Systems’ acquisition of the Design & Engineering (D&E) business, the D&E Community Forum on the Nexus Community Center has been migrated in the Cadence Physical System Simulation Community. For more details and if you have any questions, please refer to the FAQ.

Stats

More Content

Can someone suggest me the easiest way or the flow chart of converting a demo vehicle into an All Wheel Drive vehicle?

rohan.tiwari
Can someone suggest me the easiest way or the flow chart of converting a demo vehicle into an All Wheel Drive vehicle?
Parents
  • 0
    Okay so this took a bit of hacking and I'm sure there is a better way of doing it but here it goes:
     
    1- go to simulate -> ​full vehicle Analysis -> vehicle Analysis -> set full vehicle Analysis
     
    You will see that the drive bias slider is disabled and you cannot move it, to undo this:
     
    2- press the F3 key, the command window should Pop up
     
    3- Copy paste one line at a time and press enter to execute one command at a time:
     
    • interface slide mod slider_name = .ACAR.dboxes.dbox_ana_ful_par_set.s_drive_bias enabled = yes
    • interface label modify label_name = .ACAR.dboxes.dbox_ana_ful_par_set.l_drive_bias enabled = yes
     
    4- you should be able to move the slider to 50% now and press apply
     
    Nevermind it does not work, something happens after running the Simulation and the values return back to what they were
Reply
  • 0
    Okay so this took a bit of hacking and I'm sure there is a better way of doing it but here it goes:
     
    1- go to simulate -> ​full vehicle Analysis -> vehicle Analysis -> set full vehicle Analysis
     
    You will see that the drive bias slider is disabled and you cannot move it, to undo this:
     
    2- press the F3 key, the command window should Pop up
     
    3- Copy paste one line at a time and press enter to execute one command at a time:
     
    • interface slide mod slider_name = .ACAR.dboxes.dbox_ana_ful_par_set.s_drive_bias enabled = yes
    • interface label modify label_name = .ACAR.dboxes.dbox_ana_ful_par_set.l_drive_bias enabled = yes
     
    4- you should be able to move the slider to 50% now and press apply
     
    Nevermind it does not work, something happens after running the Simulation and the values return back to what they were
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.