Stats

State Not Answered
Replies 2
Subscribers 3
Views 2
Members are here 0

i have designed a chain. Now i want to remove a few links from the chain. is it possible within adams to remove an intermediate link and attach the other two remaining links without resorting to 3d modelling software.

0 Atul.Kumar over 7 years ago

Hi Abhishek,

Are you working with Adams/Machinery ?

It is not possible to explicitly remove a single geometry from the mechanism created via Adams/Machinery.

In this case, it is required to modify(~re-wrap) the chain, while you can enter the desired number of link at the "Geometry" section of the chain creation wizard.

HTH.

Regards,

Atul Kumar.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 abhishek.arora over 7 years ago

Hi Atul,

I have modelled and assembled the chain using the NX software.

regards,

Abhishek Arora
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.