Physical System Simulation

CDNS Forum Physical Categories

Actran

Adams

CAEFatigue

Cradle CFD

Digimat

Dytran

Easy 5

Elements

FTI FormingSuite

Marc

MaterialCenter

MSC Apex

MSC Apex Generative Design

MSC CoSim

MSC Nastran

ODYSSEE

Patran

Romax

SimManager

Simufact

Virtual Test Drive

Physical System Simulation

Latest Posts

Not Answered

Contact webinar WM412 is not available

Category: Adams

By varghese.john
•
updated over 2 years ago by varghese.john

2 replies • 6 views
Not Answered

Hello everyone, Is there any extra material/documentation on how aerodynamic theories such as the Piston theory can be setup in Patran/Nastran? The user guide only provides information specifically on doublet lattice and Zona51.

Category: MSC Nastran

By mscsupport
•
updated over 2 years ago by mscsupport

2 replies • 9 views
Not Answered

Can NASTRAN 2021 or later compute VonMises stresses directly in a random or sine vibe analysis directly?

Category: MSC Nastran

By derek.lewis
•
updated over 2 years ago by Sanjay Patel

1 replies • 13 views
Not Answered

Double Lane Change Simulation

Category: Adams

By HJ Yoo
•
updated over 2 years ago by HJ Yoo

2 replies • 11 views
Not Answered

Hello Team we want to run bat file dynamically access Adams2023_3 / acar / ru-st/ b/ example.cmd via MATLAB in command prompt mode but when we tried there was prompt each time to enter Adams2023_3 /acar/ ru-st/ b / example.cmd.

Category: Adams

By RSubrama
•
updated over 2 years ago by Jesper Slattengren

5 replies • 1 views
Not Answered

How to avoid “only nodal results values are available” issue in prestate analysis?

Category: Simufact

By ACopper
•
updated over 2 years ago by Simufact Support

1 replies • 9 views
Not Answered

Full vehicle simulation error

Category: Adams

By HJ Yoo
•
updated over 2 years ago by HJ Yoo

2 replies • 16 views
Not Answered

Hello, I am learning easy5 from tutorials however, I found 5 tutorial of Elements. How may i get detaail tutorials of elements software? Best regards, Samet

Category: Elements

By samet.goner
•
updated over 2 years ago by Rick Clanton

9 replies • 74 views
Answered

Hello Everyone, In my project, I used composition poppet type in the valve. However, Easy5 have two type poppets (cone and ball). May I make composition poppet in easy5? Best regards, Samet

Category: Easy5

By samet.goner
•
updated over 2 years ago by Rick Clanton

3 replies • 42 views
Not Answered

I am using Adams Machinery to model helical gears with 3D contact method, I am getting noise in the results when I compute forces at gear joints (revolute). Is there any way to avoid these noise in the result without application of filters.

Category: Adams

By skaka
•
updated over 2 years ago by Henrik.Skovbjerg

3 replies • 6 views

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.