CFView: Vortice detention and visualization

Question

I am trying to get a 3D rendering of a vortice on a rotors blade by using the quantity Lambda2. 
 I was able to do it by manually creating 33 IJK surfaces, in this case it was I surfaces to obtain this result: 
 
 Now without the surfaces: 
 
 Is there a quicker and easier way to obtain this result? I wanted the full domain but that were a minimum of 97 surfaces if i used J surfaces. 
 Do I need to just create a Macro? This is a process that I am going to need to repeat a lot and wanted to find the best way. 
 Thank you very much for any help. 
 Regards, 
 Delfim S&aacute;

Colinda · Accepted Answer

You are using CFView, right? The isosurfaces are created in all domains: when you save them, you can see in the list of surfaces a new surface that is expandable and contains the surfaces within each of the domains. In that way you can easily control which ones to look at.

Stats

CFView: Vortice detention and visualization

Community Guidelines