Stats

  • State Not Answered
  • Replies 0
  • Subscribers 19
  • Views 31
  • Members are here 0

Plotting single point AWR 24.1

DT202506236230

Hello!

How would I go about adding a singular point at a specific coordinate in a graph? 
I want to add a dot to a graph to show the P1dB. My thought was that I can just create a variable in output equations as P1dB=(x,y) and then add that as a measurement in my plot. However, it seems I can't define points in this way, or I am might not know the correct syntax. If I define it as P1dB=y then it automatically shows up at x=1 in the graph. I can't figure out how to set the x value.

I am using AWR 24.1 18.03 18789 Rev1.

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.