Stats

  • Locked Locked
  • Replies 1
  • Subscribers 129
  • Views 13543
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

questions about purpose change

sooky

Hi

I was informed that there will be some changing about the description of the purpose of layer .

e.g.

From :

M1        accessary                         

M1        accessary1                                    

M1        boundary

M1        drawing

M2        accessary

M2        accessary1                                    

M2        boundary 

To  :                            

M1       accessary

           boundary

          accessary1

          drawing

M2       accessary

           accessary1

          boundary

What is the obtainable improvement of doing this change?

I wonder that is there any differences between the two descriptions?

Will this change bring some difficult or potential risk to tool (virtuoso) operation?

 

Any information about this is ok.

Thanks

  • skillUser

     Hi,

    I'll be honest and say that I don't even understand the question!

    Where would this change be made? Which version are you using?

    Without a clearer question, I don't think that you'll get a meaningful answer.

    Regards,

    Lawrence.

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.