Stats

Locked Locked
Replies 3
Subscribers 125
Views 15009
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ADEXL Spec issue

I am evaluating the ADEXL tool and at the moment I feel a bit unhappy with it because of its bugs and limitations.

I am trying to use the pass/fail test by indicating a "Spec" range.

For example, when performing a dc temperature sweep on a bandgap, the “range 699mV – 701mV” specification on the bandgap voltage takes into account the first point at -40 degrees, and not all the points from -40 degrees to +120 degrees of my DC-TEMP sweep.

How to specify the test on the entire wave and not only on a single point?

Thanks in advance

Parents

threepwood over 16 years ago

One more time a bug due to Cadence:
impossible to post a message without "Normal 0 false etc..."
Cancel
Vote Up 0 Vote Down

Cancel

Reply

threepwood over 16 years ago

One more time a bug due to Cadence:
impossible to post a message without "Normal 0 false etc..."
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.