• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. IC6 shielding constraint

Stats

  • Locked Locked
  • Replies 2
  • Subscribers 126
  • Views 13789
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IC6 shielding constraint

stuso
stuso over 16 years ago

Hi there, has anyone managed to use wire editor to route a shielded net in IC6? I'm having an issue setting up the constraint, specifically from this document:

 sourcelink.cadence.com/.../appA.html

and from that document:

 "To create a shielding constraint and set the associated shielding net:

Select the net that is to be shielded.

Note:  If you select multiple nets, and try to apply a Shielding constraint, a consistency check warning message is displayed in the CIW."

However i seem to be getting an error in my CIW when i do not select at least 2 nets:

*WARNING* Can not delete member GND from Shielding constraint Constr_0. Constraints of this type require at least 2 members.

 any suggestion/help is appreciated.

thanks

Stu

 

 

 

 

 

  • Cancel
Parents
  • torrecdns
    torrecdns over 16 years ago

     Hi Stu,

     What version of Virtuoso are you using? This has changed recently and the document you are refering to shows the new use model. I'm not exactly sure when it changed, but it use to require to select in Navigator the shield net first, followed by shielded net (using ctrl to select both) before creating constraint in constraint manager. Give this a try.

    In either case, once the constrait is defined. Make sure you have CAE (Constraint-aware editing) ON. This is an option inthe menu Options->Layout XL...    "General" tab. You should see the shielding create when using Create->Wire... or running the autorouter.

    I just tried in ISR6 as described in doc. and works fine.

    Hope this helps,

    Fernando Torre

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • torrecdns
    torrecdns over 16 years ago

     Hi Stu,

     What version of Virtuoso are you using? This has changed recently and the document you are refering to shows the new use model. I'm not exactly sure when it changed, but it use to require to select in Navigator the shield net first, followed by shielded net (using ctrl to select both) before creating constraint in constraint manager. Give this a try.

    In either case, once the constrait is defined. Make sure you have CAE (Constraint-aware editing) ON. This is an option inthe menu Options->Layout XL...    "General" tab. You should see the shielding create when using Create->Wire... or running the autorouter.

    I just tried in ISR6 as described in doc. and works fine.

    Hope this helps,

    Fernando Torre

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information