Stats

  • Locked Locked
  • Replies 4
  • Subscribers 125
  • Views 13983
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

can lay out engineer change the width of a resistor?

VEERA PRAMOD

Hi all...

Can layout engineer change the width of a resistror by keeing the resistance constantly as in schematic? And what is the minimum length of  a resistor ?is it depends on width?

 

Thnk you.

 Veera Pramodu Kotrika.

Parents

  • Hi Veera,

    Did you really just ask this question?  I'm surprised that such a basic question is being asked, did Google not provide an answer?

    Anyway, to answer your question, the resistance of a wire (and a resistor made of resistive material, therefore) is directly proportional to the length of the wire and inversely proportional to the cross-sectional area.  There's a formula for this:

    R = p L
           A

    Where R is the resistance, "p" is rho, a resistivity constant, and L and A are length and area respectively. When laying out a resistor, you do not have control over the thickness of the resistive material (usually, but there might be some process out there...) but you do have control over the width - obviously Area = thickness X width so the area is directly proportional to the width.

    The minimum length will depend on the process limits, and these are most likely to be set and enforced by the Process Design Kit, likewise the width will have a minimum as defined by the manufacturing process.

    Hopefully this answers your question, if not, please read the hint in my first line of response.

    Regards,

    Lawrence.

Reply

  • Hi Veera,

    Did you really just ask this question?  I'm surprised that such a basic question is being asked, did Google not provide an answer?

    Anyway, to answer your question, the resistance of a wire (and a resistor made of resistive material, therefore) is directly proportional to the length of the wire and inversely proportional to the cross-sectional area.  There's a formula for this:

    R = p L
           A

    Where R is the resistance, "p" is rho, a resistivity constant, and L and A are length and area respectively. When laying out a resistor, you do not have control over the thickness of the resistive material (usually, but there might be some process out there...) but you do have control over the width - obviously Area = thickness X width so the area is directly proportional to the width.

    The minimum length will depend on the process limits, and these are most likely to be set and enforced by the Process Design Kit, likewise the width will have a minimum as defined by the manufacturing process.

    Hopefully this answers your question, if not, please read the hint in my first line of response.

    Regards,

    Lawrence.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.