Stats

  • Locked Locked
  • Replies 13
  • Subscribers 126
  • Views 21567
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Refer to another output equation in ADE

Grover

If I set up the output signals and expressions in Analog Design Environment, is it possible to refer to other expressions in an expression? For example, if I have the expressions

pin3 = (power from the 3.3 V supply)
pin12 = (power from the 12V supply)

can I then define

ptot = pin3 + pin12

in some way?

Parents

  • Thanks for the info. For not-too-complicated expressions, I prefer to just do everything in the Ouputs Setup tab. However, you said that it's necessary to define the expressions in the correct order. Is it then possible to change the order of the expressions after you've made them? Adding a new expression just adds it to the end of the list, I can't find a way to add one halfway.

Reply

  • Thanks for the info. For not-too-complicated expressions, I prefer to just do everything in the Ouputs Setup tab. However, you said that it's necessary to define the expressions in the correct order. Is it then possible to change the order of the expressions after you've made them? Adding a new expression just adds it to the end of the list, I can't find a way to add one halfway.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.