Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 12915
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Multiple strobedelays in one simulation

Dushan

Is it possible to do strobing with more than one strobedelay parameter in a single simulation? I am trying to sample the output signal right before and right after a clock edge, but don't want to run two simulations with different strobedelay since my simulations are already  too long.

 Thanks,

Dusan 

  • Hi Dusan,

    No, this is not possible. You could instead use something like two zvcvs to specify the period and delay - this will force a time point at each of the two edges - ah, hang on, you can't use that with pss (I think). So you could instead use a pulse source - it will put a breakpoint at each point on the pulse, which will force a simulation time point there.

    Then you could use the sample function in the calculator afterwards to just pick the timepoints you want for each of the two cases, and then output that to CSV.

    Regards,

    Andrew.

  •  Hi Andrew,

     It works nicely with a pulse source. Thanks a lot.

    Dusan 

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.