Stats

Locked Locked
Replies 3
Subscribers 125
Views 13326
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Relative coordinates

I want to build a box of known x and y where I want to build it from any point in the layout. I start the rectangle command and click the first point, how can I enter the points on the command line and get the box I want.

IC5.1.4.1

Thanks

Robert

Parents

Andrew Beckett over 15 years ago

Robert,

When you are prompted for points, you can just type (say) 23:45.3 in the CIW and it will be equivalent to clicking at that point.

Does that answer your question? I wasn't entirely sure what you were asking.

Regards,

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 15 years ago

Robert,

When you are prompted for points, you can just type (say) 23:45.3 in the CIW and it will be equivalent to clicking at that point.

Does that answer your question? I wasn't entirely sure what you were asking.

Regards,

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.