Stats

  • Locked Locked
  • Replies 6
  • Subscribers 125
  • Views 16991
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Change manufacturing grid for streamout in IC613

tkhan

How can the manufacturing grid size be changed when streaming out in IC613? In IC5141 there was an option to set the grid size in DBUperUU but I can't find this option in IC613 and the fab is saying the design has been streamed out at the wrong grid size. Please advise.

Parents

  • Hi Quek,

    Thanks for clearing that up. Our foundry advised that we should streamout from IC613, then streamin to IC5141 and streamout again from IC5141 using the correct DBUperUU. I figured as much, but wanted to hear from them before doing it.

    Thanks,

    Tarek

Reply

  • Hi Quek,

    Thanks for clearing that up. Our foundry advised that we should streamout from IC613, then streamin to IC5141 and streamout again from IC5141 using the correct DBUperUU. I figured as much, but wanted to hear from them before doing it.

    Thanks,

    Tarek

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.