Stats

Locked Locked
Replies 5
Subscribers 126
Views 21199
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

descend in schematic

The Consultant over 15 years ago

Hi,

if i descend into an schematic hirarchy using Shift-E , an popup apears ...

i can choose view & wher to open.

i don't want to be asked. I want to set it somewhere and never ever asked again ...

how can i do this ?

Parents

Andrew Beckett over 15 years ago

The cdsenv setting was only added in IC614 (it's not there in IC613).
In IC613 you can use the "F3" options approach that Derek outlined to change the default, and then it sould remember it each time duriung that session.
Regards,
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 15 years ago

The cdsenv setting was only added in IC614 (it's not there in IC613).
In IC613 you can use the "F3" options approach that Derek outlined to change the default, and then it sould remember it each time duriung that session.
Regards,
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.