Stats

Locked Locked
Replies 8
Subscribers 126
Views 19315
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to probe in av_extracted view?

Hello All,

I am using the cadence spectre IC5141. I am trying to simulate LC-VCO through assura layout.

I have cleared all DRC, LVC and have an av_extracted view. But when I simulate the layout / av_extracted view of this LC-VCO from config it doesnt work /oscillate.

I want to probe on various points say vdd, gnd etc in the extracted view itself and see if all the voltages sources etc are connected properly.

How to do that?

Thanks in advance.

Parents

starsky over 15 years ago

Thanks Andrew,
Can you please tell me where to go and make these nets valid?

Thanks and regards,
starsky
Cancel
Vote Up 0 Vote Down

Cancel

Reply

starsky over 15 years ago

Thanks Andrew,
Can you please tell me where to go and make these nets valid?

Thanks and regards,
starsky
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.