Stats

Locked Locked
Replies 6
Subscribers 126
Views 16648
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cadence 5: Change path width with bindkey

Without the possibility to change the default width to the correct value in the PDK, I am trying to develop a bindkey in cadence 5.1.41 which will do the trick.

hiSetBindkey("Layout" "<Key>F11" "leHiEditProp() width->value=130")

After selection of the path, I am hitting the "F11" I have the property form opening but the following is not interpreting. Does someone know how to affect the width after that?

Best regards

Parents

imaneet over 10 years ago

is it possible to change the default layer width when you draw a path? for example, when i draw metal1, the default is .24um, can i make it to .5um as the default path width? in the old ic5.0. i think you could do this.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

imaneet over 10 years ago

is it possible to change the default layer width when you draw a path? for example, when i draw metal1, the default is .24um, can i make it to .5um as the default path width? in the old ic5.0. i think you could do this.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.