Stats

  • Locked Locked
  • Replies 3
  • Subscribers 125
  • Views 13244
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

optimizing

martinmmuc

Is it possible for the circuit optimizer to

optimize Monte Carlo results?

 

I am just optimizing a latched comparator,

changing  W and L  and  try to minimize the

offset which comes out of  a 100 run Monte Carlo simulation

Thanks & Regards

 

Martin

 

Parents

  • You didn't say which version you were using, but if using IC614, you can use ADE GXL. This has things like yield optimization which will allow you to optimize to maximize yield (so you'd set up a specification, i.e. a goal, on the offset, and it can then try to optimize the circuit so that it doesn't have failures during monte carlo due to the specifications not being met).

    Regards,

    Andrew.

Reply

  • You didn't say which version you were using, but if using IC614, you can use ADE GXL. This has things like yield optimization which will allow you to optimize to maximize yield (so you'd set up a specification, i.e. a goal, on the offset, and it can then try to optimize the circuit so that it doesn't have failures during monte carlo due to the specifications not being met).

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.