Stats

Locked Locked
Replies 2
Subscribers 125
Views 13663
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

rangecnst_severity_level

Hi All,

First I apologize if it is not the correct forum for analog mixed-signal questions.

I am relatively new in AMS environment and I am having an issue while I am implemented a RTL code with the analog circuit to run AMS simulator. The netlisting and compiling part are successfull but during the elaboring part, the simulation stops with the following message:

Error! range constraint violation

Set "rangecnst_severity_level" ncsim tcl variable to ignore this error.

Does someone know where to put this variable and how to do it?

Best regards,

Parents

frogconsultant over 14 years ago

Thanks Andrew for your feedback. It works also when I am typing in the ncsim window before to run it but the file will help me not to type each time.
Regards,
Cancel
Vote Up 0 Vote Down

Cancel

Reply

frogconsultant over 14 years ago

Thanks Andrew for your feedback. It works also when I am typing in the ncsim window before to run it but the file will help me not to type each time.
Regards,
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.