Stats

  • Locked Locked
  • Replies 3
  • Subscribers 125
  • Views 13980
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

simvision schematic cross probing

swdesigner

Does anyone have a solution for plotting signals into the simvision waveform window directly from the schematic editor?

I guess simvision would be acting as a server in this case and we need to send it the appropriate command - sort of (with my primitive knowledge) the way you can tell Firefox to open a URL from the xterm command line.

Any ideas would be great..

Parents

  • Are you using AMS Designer? If so, this is possible already. You need to enable Options->Editor->Cross Selection (Cross Selection is on the Editor Options form) - set it to "yes". If you then select nodes on the schematic they will cross-select onto the browser in simvision when running an AMS "interactive debugger" simulation.

    Regards,

    Andrew.

Reply

  • Are you using AMS Designer? If so, this is possible already. You need to enable Options->Editor->Cross Selection (Cross Selection is on the Editor Options form) - set it to "yes". If you then select nodes on the schematic they will cross-select onto the browser in simvision when running an AMS "interactive debugger" simulation.

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.