Stats

Locked Locked
Replies 1
Subscribers 125
Views 13346
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Not able to reopen the saved spectre state again ...please help me

hello guys

i was designing a opamp ... i saved all variables in my design in spectre state ....which consist of W/L of all transistor biasing voltages at each node....etc but i am not able to recover it back when i tried to reload again it says following lines in CIW window

*WARNING* - Virtuoso® Analog Design Environment: No saved states for ("amplifier" "folded_razavi_CB" "spectre")

1) can anybody tell me how to load a state in ADE to run the simulation....?

2) if i save the state to anyother folder how i can reapply it to design in ADE, please tell me .....!!

thanks in advance

Andrew Beckett over 14 years ago

Not really enough information to go on - see Forum Guidelines. Saving a state and loading it again should not cause problems like this - I've not seen this. I'm assuming all checkboxes where checked on the load state form?
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.