Stats

  • Locked Locked
  • Replies 6
  • Subscribers 125
  • Views 14004
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to drive many pins using a single driver?

A98N

 Hello All,

Assuming there are 10 input pins in a schematic view need to be set at either 0 or vdd. Is there any way to set them using a signle vdc?, or 10 independent dc supplies are necessary for such a test?

 

Thanks,

A

Parents

  •  Hi Lawrence,

    In a case that those inputs should be changed duing sumulation, or at different corners,then hard wiring does not help. I remember it was possible by setting a binary number somewhere in the source then the results could be applied to a bus. But I am not sure about the details.

    Regards,

    A

Reply

  •  Hi Lawrence,

    In a case that those inputs should be changed duing sumulation, or at different corners,then hard wiring does not help. I remember it was possible by setting a binary number somewhere in the source then the results could be applied to a bus. But I am not sure about the details.

    Regards,

    A

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.