Stats

Locked Locked
Replies 6
Subscribers 125
Views 14004
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to drive many pins using a single driver?

Hello All,

Assuming there are 10 input pins in a schematic view need to be set at either 0 or vdd. Is there any way to set them using a signle vdc?, or 10 independent dc supplies are necessary for such a test?

Thanks,

Parents

Andrew Beckett over 14 years ago

Maybe this solution gives you what you want?
Regards,
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 14 years ago

Maybe this solution gives you what you want?
Regards,
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.