Stats

Locked Locked
Replies 4
Subscribers 125
Views 14946
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Analog stimuli in ADEXL error

I have created a pwl source using the analog stimuli option for a particular pin.

The pwl source has many variables (like slew rate, amplitude etc) which is defined in my design variable section of the test.

When i netlist the test, it netlists fine, there are no errors.

But when i try to run a simulation, i get the error " *WARNING* asiiEvalDesignValList: problem with variable slew

*Error* in the Design Variables. AEL's message: data type error:
cannot undefer "slew"

It feels like the analog stimuli are being read in before the design variables in some way, since in the design variables section i have the variable "slew" defined.

How should i overcome this error?

Parents

rkic over 13 years ago

I forgot to add that all the variables in my pwl have the same error not just the slew.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

rkic over 13 years ago

I forgot to add that all the variables in my pwl have the same error not just the slew.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.