Stats

Locked Locked
Replies 5
Subscribers 125
Views 1458
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ADEXL (IC615) Output Intermittently Isn't Calculated

I'm having a strange problem with ADEXL and Monte Carlo Analysis. My situation is the following- I have 3 outputs: a transient signal, the FFT of that transient signal, and an IP2 measurement, which is a simple scalar calculation on a value() of the FFT.

In 7 of my 10 iterations, the results in the "Details" section are fine. In the other 3, the IP2 measurement is not calculated and listed as failed. In these same iterations, the FFT output does not have the waveform icon in the Nominal column. However, if I right-click->Plot, the FFT will plot without problem.

Anyone have this problem or know what is causing it? I can't find any errors in any of the log files, and it seems random which ones are not calculated.

Parents

Andrew Beckett over 13 years ago

I think that should be recent enough. What about the spectre version? (you'll see this at the top of the spectre log files).
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 13 years ago

I think that should be recent enough. What about the spectre version? (you'll see this at the top of the spectre log files).
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.