• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. Do license queueing for AMS

Stats

  • Locked Locked
  • Replies 6
  • Subscribers 125
  • Views 17607
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Do license queueing for AMS

RichardCh
RichardCh over 13 years ago

Hello,

I want to do license queueing for AMS but failed.

I went to ADE, use Simulation-> Options->AMS Simulatio-> Additional Arguments

Type with following command line

irun -licq -spectre_args "+lqt 0"

The error message said there is a operator "-" that causes a problem.

I have no idea what went wrong.  I just typed the same like Solution ID:11725058 suggested.

Wish someone can help.

Regarsd,

Richard.


 

  • Cancel
Parents
  • RichardCh
    RichardCh over 13 years ago

     Hello, Andrew

     

     Actually , I filled it into APS additional options but it turned out to an error happened. 

    Now, you already gave me the answer.

    I was trying to say the loading state in ADE. I should make my description more clear.

    Loading of state takes a long time when I start simulating with LPE results via config view.

    If I run simulations with schematics only, it takes like 1 minute to load a state.

    I am not sure it is normal for simulating with LPE.

    Thanks

     

    Richard.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • RichardCh
    RichardCh over 13 years ago

     Hello, Andrew

     

     Actually , I filled it into APS additional options but it turned out to an error happened. 

    Now, you already gave me the answer.

    I was trying to say the loading state in ADE. I should make my description more clear.

    Loading of state takes a long time when I start simulating with LPE results via config view.

    If I run simulations with schematics only, it takes like 1 minute to load a state.

    I am not sure it is normal for simulating with LPE.

    Thanks

     

    Richard.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information