Stats

Locked Locked
Replies 2
Subscribers 125
Views 15506
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Saving Cadence simulation data for later use

Hello,

I am running a simulation on a circuit containing a feedback loop. It takes a long time just to converge to a steady state. Is there a way to save the converged state and load it later to start a transient simulation from that state? For example, if the circuit converges after 100ns, can I save the state of the circuit at that point, and for future simulations, load that state so that I don't have to go through the initial converging that takes 100ns? Thanks you very much.

Wonyoung

Parents

Wonyoung over 13 years ago

Thanks! This is really helpful.
Wonyoung
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Wonyoung over 13 years ago

Thanks! This is really helpful.
Wonyoung
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.