In my design, I'm working on a very old twin tub process. so, i don't
have a latchup ruledeck and so i gotta verify latchup related stuff
manually. I'm using calibre for verifications. I don't have assura etup
for this technology. I verified most of the latchup guidelines like
region related, guard ring related. etc. The process guidelines say
that power plot should be very good. So, i wanna extract all power and
ground nets individually and check whether the connectivity is good
enough or not.
Did any of you had a similar situation where you had to write a code and extract the nets? Please share ur comments on this.
In IC615 you could use the Connectivity->Nets->Mark command, and then use the Connectivity->Nets->Save All Mark Nets to save the resulting shapes to another cellView.