• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. Using a "bus" in outputs setup in ADEXL in Spectre

Stats

  • Locked Locked
  • Replies 0
  • Subscribers 125
  • Views 466
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Using a "bus" in outputs setup in ADEXL in Spectre

Hello Sailor
Hello Sailor over 13 years ago

I want to test a digial bus against a spec. in the Outputs Setup of ADEXL....

 e.g. I have in the schematic a bus d<7:0>, I want to test if at say 100 us it is equal to some value i.e 0xff

Thanks

  • Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information