Stats

  • Locked Locked
  • Replies 10
  • Subscribers 128
  • Views 19671
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DC bias operating point, IC6.14, MMSIM10

Kabal

 Im trying to figure out how can i obtain DC biased operating point when doing different type of simulation in MMSIM10, under IC6.14?

 

Lets say i have some complicated circuit, and i put specific nodes for plotting (either in ac,dc,tran...and so on).

 But at the same time, i want to have a quick access to a list of table or something, which would tell me DC operating point at each node, as well as all transistor important voltages and currents, like Vgs,Vds...IDs and so on.

 (i always used to do that in free Spice software LTSpice, but i really want to know how could i do something like that in cadence?)

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.