Stats

Locked Locked
Replies 9
Subscribers 127
Views 8574
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

drawing/logo in a schematic view

Aldo2 over 13 years ago

Hello,

is there a way to import/generate a drawing/logo in a schematic view?

Thank you

Aldo

Parents

thorstenb over 8 years ago

Hello Andrew !

This is great, thank you very much for following up that quickly to a relatively old thread.
Yes, I will send the xpm via private comms to solve the issue.

Best Regards,
Thorsten
Cancel
Vote Up 0 Vote Down

Cancel

Reply

thorstenb over 8 years ago

Hello Andrew !

This is great, thank you very much for following up that quickly to a relatively old thread.
Yes, I will send the xpm via private comms to solve the issue.

Best Regards,
Thorsten
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.