Stats

Locked Locked
Replies 3
Subscribers 127
Views 14992
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

how to generate ideal balun in layout?

Hello everyone
i have generated layout of OTA design shown below. DRC is sucessfully run without ideal_balun
But i dont know how to connect ideal_balun in layout. please help me i got xfmr component error in LVS.
I have removed the ideal balun and put voltage sources with pins connection.
but problem is that i want to apply both differential voltage and input common mode voltage simultaneously. how can i apply it?
How can i solve it? thanks in advance

Parents

Frank Wiedmann over 11 years ago

See http://www.designers-guide.org/Analysis/diff.pdf
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Frank Wiedmann over 11 years ago

See http://www.designers-guide.org/Analysis/diff.pdf
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.