• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. Simulation Progress, IC6.14, MMSIM10

Stats

  • Locked Locked
  • Replies 5
  • Subscribers 125
  • Views 15935
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Simulation Progress, IC6.14, MMSIM10

Kabal
Kabal over 13 years ago

 I cant find howis it possible to see a simulation progress while its running in ADE XL(GXL)? On the lower left corner i see the running -0/1 complete, but i want to see the % of completion. Is there any way i can do that?

  • Cancel
Parents
  • Andrew Beckett
    Andrew Beckett over 13 years ago

     Which IC614 version are you using? (Help->About in the CIW will tell you, or typing getVersion(t) in the CIW).

    I recall there being an issue where the Output Log menu was greyed out, but I thought it was longer ago than that - I can't quite remember  off the top of my head.

    The Status mode is to show you the overall simulation progress, primarily when you're running many simulations - so if you were running multiple corners, it would show you the overall progress. The output log would tell you within a single run - so we need to find out why that's not working (note, IC614 is no longer supported...)

    Andrew

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • Andrew Beckett
    Andrew Beckett over 13 years ago

     Which IC614 version are you using? (Help->About in the CIW will tell you, or typing getVersion(t) in the CIW).

    I recall there being an issue where the Output Log menu was greyed out, but I thought it was longer ago than that - I can't quite remember  off the top of my head.

    The Status mode is to show you the overall simulation progress, primarily when you're running many simulations - so if you were running multiple corners, it would show you the overall progress. The output log would tell you within a single run - so we need to find out why that's not working (note, IC614 is no longer supported...)

    Andrew

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information