I am using 6.1.5 environment and I have ran a monte-carlo simulation over 100 runs yesterday and I load back my results. Some runs have failed and I wish to see more data on these particulars seeds. I went to the monte-carlo options and choose the specific seed number and re-run only this one with monte-carlo.
As a result, I do not have the correct seed environment and so the same results.
How could I re-run a specific seed number from a monte-carlo run with all data such dc voltage, dc operating point, waveforms specified, ...?
Thanks in advance for your help,
Thanks for your quick reply.
I select the run number of interest and create a statistical run after reloaded the monte-carlo run from yesterday (reload results). Then run only this new run as a Single Run, ...
The outcome results are not the same as the specific one selected. How could I make sure this new run created is the one which failed in the monte-carlo run?