I am using 6.1.5 environment and I have ran a monte-carlo simulation over 100 runs yesterday and I load back my results. Some runs have failed and I wish to see more data on these particulars seeds. I went to the monte-carlo options and choose the specific seed number and re-run only this one with monte-carlo.
As a result, I do not have the correct seed environment and so the same results.
How could I re-run a specific seed number from a monte-carlo run with all data such dc voltage, dc operating point, waveforms specified, ...?
Thanks in advance for your help,
I agree that this is a little more difficult, but it should still be doable, for example by using information from an LVS run. Of course, a first step should be to give consistent results for a modified version of the same view (including an extracted view).