Stats

  • Locked Locked
  • Replies 1
  • Subscribers 125
  • Views 14647
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Virtuoso does not save certain nodes during transient simulation

Wonyoung

Hello,

I have a problem that Cadence Virtuoso sometimes does not save certain voltage nodes. This occurs even when I select "all"  in "Select signals to output (save)" in ADE when running transient simulations. When I try to plot the voltage of certain nodes after the simulation, I get a warning saying "no VT data for node XXX". I am using Virtuoso 6.1.5. Any advice is appreciated! 

Regards,

Wonyoung 

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.