Stats

  • Locked Locked
  • Replies 18
  • Subscribers 128
  • Views 29976
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Hysteresis sweep option in DC

sohaiba

Hi,

I haven't been able to see a Hysteresis plot by using the DC Hysteresis sweep option. I have also enabled the 'DC operating point' option as well. I was expecting to find a negative going plot as well for the device but there is only a single Voltage transfer characteristic curve.

 Following are the settings the Cadence spectre.out shows.

Important parameter values:
    reltol = 1e-03
    abstol(V) = 1 uV
    abstol(I) = 1 pA
    temp = 120 C
    tnom = 27 C
    tempeffects = all
    gmindc = 1 pS
    hysteresis = on

Which verifies that hysteresis option is "ON".  I am using MMSIM 11.1 and Cadence 6.1.5. Could you indicate where I could be going wrong?

Regards

 

 

Parents
  • Pyroblast
    Did you tried without using the Hysteresis option, in the dc analysis?
Reply
  • Pyroblast
    Did you tried without using the Hysteresis option, in the dc analysis?
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.