Stats

  • Locked Locked
  • Replies 4
  • Subscribers 125
  • Views 15352
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

A problem of spectre simulation

heli
when i use  spectre simulate a circuit, the spectre.out file report errors(shown as below); in model file, I have already assigned a value to nmos_1p8_noia, why spectre still report error? Is that mean the version of my spectre is too old?
Parents

  • Hi Andrew, the parameter is in model file indeed, so I can not post here, but I think you are right, the version of spectre I'm using is too old, I'll take your advise that using new version spectre.Thanks, Andrew, your suggestion help me a lot.

     

    Regards, HeLi 

Reply

  • Hi Andrew, the parameter is in model file indeed, so I can not post here, but I think you are right, the version of spectre I'm using is too old, I'll take your advise that using new version spectre.Thanks, Andrew, your suggestion help me a lot.

     

    Regards, HeLi 

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.