• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Custom IC Design
  3. noise analysis

Stats

  • Locked Locked
  • Replies 4
  • Subscribers 126
  • Views 14878
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

noise analysis

surreyian
surreyian over 12 years ago

Hello,

 After running noise analysis, printed noise summary.

I couldnt understand te Param info from the summary.

What is fn, id, rs etc stands for?

Is the total input referred noise = total summarised noise/gain^2 ?

 

 

  • Cancel
Parents
  • Andrew Beckett
    Andrew Beckett over 12 years ago

    fn is the flicker noise, id is the drain current noise, rs is the source resistor thermal noise, etc.

    Unfortunately the parameters are not yet documented (there's a request for this), but once you know the basics above it's fairly obvious what they mean (for a couple of more esoteric models it's less obvious, but in general it's clear enough).

    Yes, input referred noise is found by dividing by the gain (or gain^2) depending on the units. Essentially the simulator only computes the output noise, but because you told it where the input was, it can also compute the gain from input to output and use that to input-refer the noise.

    Regards,

    Andrew.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Reply
  • Andrew Beckett
    Andrew Beckett over 12 years ago

    fn is the flicker noise, id is the drain current noise, rs is the source resistor thermal noise, etc.

    Unfortunately the parameters are not yet documented (there's a request for this), but once you know the basics above it's fairly obvious what they mean (for a couple of more esoteric models it's less obvious, but in general it's clear enough).

    Yes, input referred noise is found by dividing by the gain (or gain^2) depending on the units. Essentially the simulator only computes the output noise, but because you told it where the input was, it can also compute the gain from input to output and use that to input-refer the noise.

    Regards,

    Andrew.

    • Cancel
    • Vote Up 0 Vote Down
    • Cancel
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information