Stats

Locked Locked
Replies 2
Subscribers 125
Views 13409
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

schematic licenses usage

Hi,

Recently we found that in order to do LVS or RCX run using calibre, a schematic license is required for exporting the cdl netlist.

Do we need to have a schematic license available in order to run LVS or RCX?

Is there any option we can set to successfully export the cdl netlist without the need of the schematic license?

Thanks

Andrew Beckett over 12 years ago

This is correct behaviour. CDL Netlisting requires a schematic license. There was an issue that if you only had Schematic-XL licenses, it wouldn't check the license back in after CDL netlisting, but that was fixed in IC615 ISR10 (6.1.5.500.10) - but it still requires a license.
Regards,
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel
navi2582 over 12 years ago

Thanks Andrew for the confirmation!!
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.