Stats

Locked Locked
Replies 2
Subscribers 125
Views 8078
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Virtuoso - Wire Bus Connectivity Issue

Hello,

I am facing this issue regarding how to connect the wire bus connection to the output connectors. If you look at the attached image below I have clearly named each bus bit to its output but I am still facing error.

Bus_output

The screenshot image displaying the error is below

Error Prompt

Any help would be appreciated.

Regards

Andrew Beckett over 12 years ago

The key is labelling the whole bus. I also label the taps as they exit the bus - I didn't explore too much what does and doesn't work, but the picture I've uploaded works correctly - so hopefully that will allow you to do what you want (the inverter on the left end was just a means of me creating a 6 bit bus as it is an iterated instance; it shouldn't make any difference that you have a symbol with a bus pin).
Regards,
Andrew.
- bustap.png
- View
- Hide
Cancel
Vote Up 0 Vote Down

Cancel
sohaiba over 12 years ago

yes thank you. it works.I didn't tag the bus wire.
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.