Stats

Locked Locked
Replies 3
Subscribers 125
Views 13730
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DioMod: To check Junction breakdown

Hello,

I am working on the ESD protection circuit. But while simulating the devices, the junction breakdown warning does not come only the oxige breakdown warning comes in all cases. In the model parameters the DioMod=1. Which means that the junction breakdown is not modelled. can I edit the diomod to check junction break down values.

Thanks and Regards

M Arshad

Parents

waseemarshad over 12 years ago

Thanks for the reply.
Do i have to change it in the .scs model file.
Or it could be edited from ADE or transistor properties.

Regards
waseem
Cancel
Vote Up 0 Vote Down

Cancel

Reply

waseemarshad over 12 years ago

Thanks for the reply.
Do i have to change it in the .scs model file.
Or it could be edited from ADE or transistor properties.

Regards
waseem
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.