Stats

Locked Locked
Replies 1
Subscribers 125
Views 13691
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Getting weff or leff Value in DC Analysis

Hello,

I would like to see the value of weff and leff after DC analysis (without any sweep, with savin DC OP). How do I call weff or leff in ADE 5.1 in outputs?

Note: Defining output as OP("/N18_0" "weff") does not work

Best,

Can

Andrew Beckett over 12 years ago

Hi Can,
I wouldn't expect "weff" to be an operating point parameter, but an "output" parameter of the device. So try doing:
pv("/N18_0" "weff" ?result "output")
Regards,
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.