Stats

  • Locked Locked
  • Replies 2
  • Subscribers 125
  • Views 14782
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ADEL check model files and paths

acook

Hello,

I would like to create a trigger that checks my model libraries and paths when I run a simulation. It would check the model paths as well as the model files. If they are not set to the EDA defaults, I would like a dialog box to come up warning me that I am simulating with a non-standard set of models.

The trigger would occur when I hit the run button in ADE. If that is not possible, it would run when I load an ADE state.

I've had time where I used my own models for weeks unknowningly because I had needed to make a change to the models at one point for one reason or another.

I am running CDS6

 Thank you,

Aaron

Parents
  • acook

    Let me rephrase into smaller peices:

    1. How do I create a trigger that will execture immediatly after I hit "run" in ADE?
    2. How do I get the information of which model files I have loaded from ADE into SKILL?
Reply
  • acook

    Let me rephrase into smaller peices:

    1. How do I create a trigger that will execture immediatly after I hit "run" in ADE?
    2. How do I get the information of which model files I have loaded from ADE into SKILL?
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.